液晶显示器维修重点笔记（Key note of LCD maintenance）.docVIP

液晶显示器维修重点笔记（Key note of LCD maintenance） Key note of LCD maintenance Disassembly and assembly 1, screw type: screw all knocked out 2: buckle: with a blade or ruler 3, pull down type: first destroy the following screws, and then pull down Two, change the high pressure plate Remove the high pressure parts and replace them with a new universal high pressure plate. 1, working conditions: (Interface) (1) VCC (12V - 19V) +GND (capacitor negative pole) VCC - insurance, capacitance (2) ENA or ON/OFF or SW - switch control (3) ADJ or DIM or BRGHT - brightness adjustment 2, type: Single lamp (size, mouth) to change a few lights, lights must be full, or else protection, general tube about 8W (double the size of the mouth) Four lights (size, mouth) Six lights (size, mouth) Three, LCD fault phenomenon A: sixteen point phenomenon 1 、 the indicator light is not bright Power supply section Driver board The button board itself 2, the light does not shine when it is lit High pressure plate Driver board Screen (minority) Short circuit (power board or high voltage board) 3, the indicator lights, but quickly destroy the image High pressure plate with lamp tube Overcurrent protection 4, the light, the image displaying, later put out High pressure plate 2. Lamp leakage 5, the indicator light flashing, there is no image display High pressure plate The board (power board) has slight short circuit (capacitance drum package) Driving tube (field pipe) breakdown Driving board 6, boot white screen Screen power supply causes (short circuit, open circuit, no) Screen itself causes Driving plate 7, boot red screen Lamp tube Screen power supply 8, a variety of flower screen Driving plate Screen II VGA line Screen line 9 、 moving bright line Driving plate Screen II 10, boot with image display, stop flashing screen Samsung T190 typical key board leakage Poor contact (screen line interface) 11, automatically jump out of the menu Button leakage Driver board 12, display beyond the frequency range Driving