填充墙（Infill wall）.docVIP

填充墙（Infill wall） I. material requirements 1. Strictly control the quality of approach blocks, including strength, geometry, appearance and so on; 2, block and brick in the masonry, a day ahead of watering, wet enough, is strictly prohibited to dry brick on the wall. Two, rebar requirements 1, the location of the steel bar according to inverted modulus method accurate positioning, the first row of rebar from the ground 30cm, upward spacing of 50cm, drilling depth and diameter must meet the design requirements; 2, hole cleaning, use special electric hair dryer, to ensure the cleaning effect of dust; 3, the wall pulling reinforcement, tensile test qualified for masonry; 4. The setting of the constructional column is strictly arranged according to the requirements of the construction drawing. The length of the longitudinal joint must meet the requirements of the design, and the stirrups in the overlap area shall be encrypted according to the requirements; 5 when the constructional column adopts the post planting steel bar, the length of the steel bar should be ensured to meet the requirement of the length of the lap joint. Three. Other requirements 1, all with the water requirements of the room wall adopts C20 fine stone concrete according to the strong regulatory requirements (200 mm high, width and wall thickness) of concrete pouring, pouring, all parts must be chiseled, and rinse with water, pouring must ensure the vibration compacting; 2, the floor masonry material stacking placed as far as possible by the wall, should not focus on dispersion; 3, all precast lintel must be strictly in accordance with the design drawings and related standards for production, production is completed with ink mark under the direction, to avoid reverse steel position during installation; 4, 28 days ahead of time to make precast lintel requirements, installation must ensure that the strength meets the design requirements. Four. Construction requirements 1, all wall masonry three lines of