微机原理考题（Microcomputer principle examination questions）.docVIP

微机原理考题（Microcomputer principle examination questions） 1. (1) MOV SI, 100 correct. Source: immediate number addressing, purpose: register addressing (2) MOV, BX, VAR1[SI] Correct。 Source: register relative addressing. Purpose: register addressing (3) MOV, AX, [BX] Correct。 Source: register indirect addressing. Purpose: register addressing (4) MOV, AL, [DX] Mistake. When register indirect addressing, DX, AX, CX can not be address register (5) MOV, BP, AL error. Operand type not consistent (6) MOV, VAR1, VAR2 error. Data cannot be transmitted between two storage units using the MOV instruction (7) MOV, CS, AX error. CS cannot be the destination operand (8) MOV, DS, 0100H error. When the operand is a segment register, the source operand cannot be immediate (9) MOV, [BX][SI], 1 errors. The instruction type is indeterminate. (10) MOV, AX, VAR1+VAR2 Mistake. The addition operation cannot be completed in the MOV instruction (11) ADD, AX, LENGTH, VAR1 correct. Source: immediate number addressing. Purpose: register addressing (12) OR, BL, TYPE, VAR2 correct. Source: immediate number addressing. Purpose: register addressing (13) SUB, [DI], 78H error. The instruction type is indeterminate (14) MOVS, VAR1, VAR2 Correct。 Both destination and source are implicit addressing. Operand only indicates operand type (15) PUSH 100H Mistake. Press constants into the stack, through registers (16) POP CS error. The destination operand is not CS (17) XCHG, AX, ES error. The operand of the XCHG instruction cannot be a segment register (18) MOV, DS, CS Mistake. MOV instructions cannot range from segment registers to segment registers (19) JMP L1+5 Correct。 Direct transfer within segment (20) DIV, AX, 10 Mistake. Instruction format error. (21) SHL, BL, 2 Mistake. The shift number of the shift command is 1 or CL (22) MOV, AL, 15+23 Correct。 Source: immediate number addressing, purpose: register. Compile time is processed to 38 (23) MUL CX Correct。 Source: register addressing, purpose: register ad