低温甲醇洗装置流程简述（Low temperature methanol washer process description）.doc

下载文档 降价啦

6
0
约1.8万字
约 12页
2017-08-04 发布于河南
举报
版权申诉
保障服务

低温甲醇洗装置流程简述（Low temperature methanol washer process description）.doc

1、本文档共12页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

低温甲醇洗装置流程简述（Low temperature methanol washer process description） 1. Brief description of the process of cryogenic methanol washing device: 1. Change the washing and pre-cooling of gas The transformation gas from the transformation process is first entered into the ammonia washing tower (C2407). The most ammonia in the gas is washed down by the boiler feed water, and the washing wastewater is used to process the carbon monoxide transformation process D2307. After washing the transformation from the recycle gas compressor and gas (K2401) and the cooler (E2402) cooling cycle of mixed gas, mixed gas injection of a small amount of methanol, to prevent the process gas water vapor freezes at low temperature. The process gas into the gas cooler E2401A after spray and E2401B shell side, respectively and purify air and exhaust gas to heat transfer, process gas gas temperature drop to - 20 ℃ or so, and then into the transformation gas/methanol water separator (D2401), the separation of methanol and water. The gas from the separator enters the bottom of the methanol washing tower (C2401), and the separated condensate is sent to the methanol dewatering tower (C2405) for the distillation and purification of methanol. 2. The removal of CO2 and H2S in the raw material gas Into methanol washing tower shift gas treating bottom-up and top-down countercurrent contact, the methanol solution of removal of H2S + COS of feed gas and CO2 respectively, finally in gas purification for methanol washing tower top out to 55 ℃, and in the gas CO2, H2S and COS removal to control indicators (content is about 2% of CO2 and H2S + COS 0.1 PPM). Then the purified gas/methanol heat exchanger (E2403), gas cooler (E2401A) heat transfer to 30 ℃ or so, after pressure 3.1 MPa to hydrogen purification process further refined purified. (the fischer-tropsch synthesis gas flow can be directly sent to the indirect liquefaction; when using IGCC matching process will be expected to enter E2314 preheat to 150 ℃ and