管槽施工（Tube slot construction）.docVIP

管槽施工（Tube slot construction） Metal wire groove, bridge mounting 1. Measurement positioning Use the bullet line method to identify the mounting position of the bridge, determine the fixed position of the good bracket, and mark it well. The positioning of the bridge in the vertical shaft should be determined by the suspension wire method to determine the installation reference line. If the reserved hole is not suitable, adjust it in time and repair it. 2. Production and installation According to the design of the construction drawing design and the bridge frame specification, the positioning is made, then the bracket is made according to the measurement dimension, and the bracket is made in factory production. Install or rely on the wall bracket, combine the structural member in the public place and consider the building beautiful and easy to overhaul, use the wall, pillar bracket installation or the installation of the lower string member of the roof. The mounting bracket shall be fixed with expansion bolt and the spacing of the bracket shall not exceed 2 meters. In linear and non linear joint, building deformation joint and the bend radius is larger than 300 mm of Central Line segment should add a hanger, the installation should guarantee the steam-water bridge horizontal or vertical degree requirements. 3. Installation of bridge frame A. For the special shape bridge frame, the dimensions of the site measurements should be submitted to the material supplier, which shall be made by the supplier according to the size and reduce the on-site processing. The bridge frame material, model, thickness and accessories meet the design requirements. B. Before installation of the bridge, it must coordinate with each professional to avoid conflict with large-caliber fire pipe, spray pipe, cold and hot water pipe, drainage pipe and air conditioning and exhaust equipment. C. will bridge lifting to the desired location, and stent using bolted, carefully check the size on a bend brid