ENGINEERING SPECIFICATION FIBERGRATE#174; …（工程规范FIBERGRATE # 174;）.pdfVIP

ENGINEERING SPECIFICATION FIBERGRATE® MOLDED HIGH LOAD CAPACITY (HLC) GRATING SECTION 06610 FIBERGLASS REINFORCED PLASTICS (FRP) FABRICATIONS MOLDED HIGH LOAD CAPACITY (HLC) GRATING PART 1 - GENERAL 1.01 RELATED DOCUMENTS A. Drawings and general provisions of Contract, including General and Supplementary Conditions and Division 1 Specification Sections, apply to this section. B. DRAFT of The Fiberglass Grating Manual, ANSI/ASCE/ACMA C. The publications listed below (latest revision applicable) form a part of this specification to the extent referenced herein. The publications are referred to within the text by the designation only. AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) Test Methods: ASTM D 635 Rate of Burning and/or Extent and Time of Burning of Self-Supporting Plastics in a Horizontal Position ASTM E 84 Surface Burning Characteristics of Building Materials 1.02 SUMMARY A. This section includes shop fabricated fiberglass reinforced plastic (FRP) Molded High Load Capacity (HLC) Grating. 1.03 SCOPE OF WORK A. Furnish, fabricate (where necessary), and install all fiberglass reinforced plastic (FRP) HLC gratings with all appurtenances, accessories and incidentals necessary to produce a complete, operable and serviceable installation as specified herein. . 1.04 SUBMITTALS A. Submit manufacturers shop drawings of all fabricated gratings clearly showing material sizes, types, styles, part or catalog numbers, complete details for the fabrication of and erection of components including, but not limited to, location, October 26, 2004 1 Revis