基牙不同轴面聚合度对GI-Ⅱ全瓷冠抗碎裂载荷影响的研究.pdfVIP

n腔颌面修复学杂志2008年1月第9卷第1期 · 论著· 基牙不同轴面聚合度对GI一Ⅱ全瓷冠抗碎裂载荷影响的研究术 刘利苹 牟月照 【摘要】目的：研究3种不同的牙体轴面聚合度(5。，10。，15。)对GI-Ⅱ全瓷冠抗碎裂载荷的影响，为临床全 瓷冠基牙预备找到较合适的轴面控制角度提供参考依据。方法：制备3组离体牙的轴面聚合度分别为5。，10。， 15。，在其上制作GI一Ⅱ全瓷冠，固定形成试件后加压直至冠碎裂，采集数据后进行单因素方差分析。结果：5。 与10。的轴面聚合度对GI-Ⅱ全瓷冠的抗碎裂载荷的影响无差别(PO．05)；而15。组与5。、l0。组相比较则有显 著性差异(P0．05)。结论：超过一定范围的轴面聚合度对GI-Ⅱ全瓷冠的-抗碎裂载荷能力是有影响的。 关键词：基牙；轴面；聚合度；GI-Ⅱ全瓷冠；抗碎裂载荷 [中国图书分类号]R783 [文献标识码]A [文章编号]1009—3761(2008)01—0005—04 Effect ofdifferent convergence angles ofabutment axial surface on the fracture resistance ofGI—II all-ceramic crowns UU Li-ping．MU Yue—zhao．1Department ofProsthodontics，Yantai stomatological Hospital 264001．China) [Abstract]Objective：To explore the effect ofthree different axial wall convergence angles(5。，10。，15。)on the fracture resistance of GI—II all—ceramic crowns．Methods：Three different axial wall convergence angles(5。，l0。，15。)were prepared respectively．All—ceramic crowns were fabricated with the GI—II all—ceramic repairing system．Then 1 5 specimens were loaded with compression to failure．The computer connected with testing machine collected and analyzed all signals． ResulIs：No significant difference was found in the failure load values between GI．IJ al1．ceramic crown s with the convergence of 5。and l 0。 0．05)．But higher failure load values were obtained from the GI—II all ceramic crowns with the convergence of l 5。than those with that of 5。and l 0。fP0．05)．Conclusion：Convergence angles in special scope are able to affeCt the fracture resistance of GI．IJ al1．ceramic crown s． Key words：abutment；axial surface；convergence angle；GI—II all——ceramic crown ；fracture resistance 随着全瓷冠修复体应用的不断增加，人们对其的 髓治疗嘲。因此，对全瓷修复体