铝合金脱模剂（Aluminum alloy release agent）.docVIP

铝合金脱模剂（Aluminum alloy release agent） With 7005 wire welding 7005 die casting, in the welding place appear oil and gas bubbles, welding method for argon arc welding. The general has the following problems: 1. of the surface of the wire and the die casting with oil, not clean; 2. commercially available pure argon gas, argon some impurities, even contains water vapor, gas should be of high quality. Alloy die casting if the die angle control is not good, often appear die surface angle, how to calculate this angle? The die slope of the die is different according to the height of the alloy and the casting. General Aluminum Alloy die casting die 3mm~250mm: wall height from the draft by 5o 30′ ~0o 30′ the outer wall, draft the half round; core draft, according to 4o ~0o 30′. The output angle of the text symbol is 10ordm, ~15o how to subdivide the block and the selection of the slope value of each gear, see the design manual of the die or the standard of the die casting material. Die casting generally not treated with T6. 2. if the T6 treatment, surface color (gray 3. deformation or not, depends on the shape of the casting itself and in the furnace are placed properly. As long as attention, generally not deformation. 4. just out of die casting die in the water, up to T6 effect. Zinc alloy plating blister. Poor electroplating can be caused by electroplating process and surface quality of die-casting parts. Die castings shall ensure good surface quality, and shall not have defects such as loose, cracks, pores, bubbles, shrinkage holes, cold lines, pinholes, etc. otherwise, the surface of the casting is easy to blister and the coating is separated from the substrate. When grinding and polishing before plating, be careful not to wear too much. Because the solidification of the die casting process, the surface of the cold formed a dense layer of cold, and the internal organization may have holes, shrinkage holes and other defects. Do not remove the good surface grinding, otherwis