道路试验段（Road test section）.docVIP

道路试验段（Road test section） Filling subgrade construction process and steps: according to the three stage, four section, eight process construction process, organization and construction The three stage: preparation stage, construction stage, repair and acceptance stage Four section: filling section, smooth section, rolling section, detection section Eight process: construction preparation, substrate treatment, layered filling, paving, leveling, sprinkling, drying, rolling compaction, testing subgrade renovation 1, subgrade filling and compaction according to three stages, four sections, eight processes construction process, organization and construction. 2. The base treatment divides the operation section first, and the principle of dividing the section of the operation area is to ensure the construction without interference and prevent the trans regional operation. Each operation section should be 200-300 meters. Then remove the basement surface vegetation, digging roots, for temporary drainage facilities, in situ surface of steep slope in 1:10 area should be the first excavation of lap platform, processing steps, lap width not less than 2 meters platform. Thereafter, the base is leveled and rolled, and the base tests are carried out according to different surface soil with different test methods. After the test has been qualified, the main party can fill the ground. 3. The filling method is based on the full width and vertical horizontal layering of the cross section. Fill the thickness of the virtual laying according to the parameters determined by the test section. Such as scraper construction, according to the thickness of the loose shop once in place; if the use of dump trucks to unload soil, should be calculated according to the capacity of the pile soil spacing, so that the formation of uniform thickness control. In order to ensure the quality of slope compaction, the sides of the subgrade should be widened by 40-50 cm at the time of filling. 4. The paving is