钎探（Testboring）.docVIP

钎探（Testboring） Testboring medical aircraft Brazing is the steel into the soil, according to the need of some footage of the allowable bearing capacity on detecting the number of soil or soil rough estimate of a simple detection method. The method is applicable to the quality inspection of the foundation of the building or the structure and the quality of the bottom soil of the pit (trough). Construction preparation 2.1 materials and main equipment 2.1.1 sand: medium sand. 2.1.2 main tools: 2.1.2.1 manual drilling: general steel, with a diameter of 22 ~ 25mm steel made a 60 degree cone shape, drill bit, drill length 1.8 ~ 2.0m; 8 to 10 pounds. 2.2.2.2 mechanical drilling: Portable sounding device (Beijing area will be provided). 2.2.2.3 others: hemp rope or wire, ladder (stool), trolley, crowbar (pull drill rod used) and steel tape etc.. 2.2 operating conditions: 2.2.1 foundation soil has been excavated to the foundation pit (trough) bottom design elevation, the surface should be smooth, the axis and pit (groove) width and length are in line with the design drawings. 2.2.2 draw the layout plan of drill hole location according to the design drawing. If the design does not have the special stipulation, may carry on according to table l-6. 2.2.3 during the night construction, adequate lighting should be provided and reasonable arrangements shall be made to prevent drilling or leakage. 2.2.4 the drill bar is marked with 30cm lines. Edit the operation process of this paragraph 3.1 process: put in place to drill line drilling drill drawing sand down down record blowcount check Kong Shen 3.2 according to the drilling hole layout line; hole pin on small stakes or sprinkle with lime. 3.3 in drilling 3.3.1: the tip of the manual drilling drill holes, a righting drill rod, a man standing on the operating bench top drill rod with a hammer; hammer lifting height is 50 ~ 70crn, the drill into the vertical soil. 3.3.2: mechanical drilling rod tip penetration holes, then the penetra