分析红外线摄像机技术（Infrared camera technology）.docVIP

分析红外线摄像机技术（Infrared camera technology） The reason why infrared cameras produce snowflakes Many friends often listen to the user calls, reflecting their use of the camera as well as the usual white, bright, and lots of snow, the evening, as we start with the world of snow; R D department colleagues also feel unbelievable, electronic security market made a special trip to the franchise took a few low-grade red brand tried, if not, the effect of day and together, one night, snow; so, we do experiments, tried the infrared lamp and the circuit board changed, also tried to change CCD, but also to a local experiment, different later, summarize the situation and snowflake produce the following reasons. Insufficient current causes snow to occur Some outdoor short distance with centralized power supply 12V is very convenient, but if it is a long distance can not use the original centralized 12V switching power supply; for a long distance infrared heat, 12V power supply instability may lead to insufficient power; and all not prone to burn with built-in cooling device in the current unstable situation; two is the current decay speed may cause the infrared light can not work properly in CCD illumination is relatively high and get to infrared auxiliary light, so the snow; Infrared light is of poor quality, the angle and distance of infrared lamp with lens does not match the cause of snow drift Many companies in order to facilitate the procurement and installation of their own, with a variety of different light mixed together, so that the advantages of using the same light they can barely use different size mm lens, the downside is always make people feel the light angle and distance and lens is not appropriate, when the angle is not appropriate. Prone to flashlight phenomenon or narrow phenomena; when the distance does not match, for example, you use a 12MM lens, but with ten to twenty meters of light, then you will appear gray phenomenon; a distant blur, near the snow; also, po