autocad应用技巧（autocad应用技巧）.docVIP

autocad应用技巧（autocad应用技巧） The application of AutoCAD technique 1. perform editing commands, prompting the target, using rectangle mode choice, drag the cursor from left to right, Windows window, if from right to left drag the cursor is cross Cross. 2. the relative coordinate input point, in the orthogonal state, general input: @x, 0 or @0, Y input (such as the relative coordinates of @100,0 under a relatively X direction on the increase of 100, and as the input coordinates of @0,50 under a relatively Y direction on the increase of 50), the above two kinds of circumstances, you can directly enter the 100 or 50 can achieve the same purpose, so as to save the input time. 3. in AutoCAD sometimes cross point markers at the click of a mouse, with the BLIPMODE command input OFF can eliminate it in that line. Some 4. users of the AutoCAD will be found in the command prompt dialog box will become, such as printing command, control it is a system variable CMDDIA, turn off it. The 5. generation command is ellipse elliptic to polyline or ellipse for the entity is determined by the system when the variable PELLIPSE is 1, PLINE is the generation of ellipse. 6. CMDECHO variables determine the command line echo is generated, the program execution should be set to 0. 7. DIMSCALE determines the dimension ratio, its value is an integer, the default is 1, in a certain proportion of graphics zoom should change the zoom ratio become the best. High CAD version 8.7 provides tolerance, but the roundness and coaxiality of the circle is not round, in fact, the definition of a symbol in the AutoCAD installation directory under the SUPPORT directory of the gdt.shp file in the common AutoCAD, the No. 2 and No. 4 character defined circular shapes, circular arc unexpectedly 127 degrees, but not too good correction (such as for 90 degrees more ugly). 9.8 hollow shaped Chinese characters such as the use of AutoCAD R14 in the BONUS function (must be fully installed AutoCAD, or custom installation chos