Cadence PCB设计高级培训班.doc

Cadence PCB设计高级培训班 课程进度安排 时间 课程大纲 第一天 9:00|12:00 1 高速PCB设计中的理论基础????传输线理论、信号完整性（反射、串扰、过冲、地弹、振铃等）、电磁兼容性和时序匹配等等。2 SPECCTRAQuest设计流程????2.1 Pre-Placement????2.2 Board Setup Requirements for Extracting and Applying Topologies????2.3 Database Setup Advisor????????—Cross-Section????????—DC Nets????????—DC Voltages????????—Device Setup . ??—SI Models????????—SI Audit 13:30|16:30 3 拓扑结构的抽取与仿真 Extracting and Simulating Topologies ????3.1 Pre-Route Extraction Setup—Default Model Selection.????3.2 Pre-Route Extraction Setup—Unrouted Interconnect ????3.3 Pre-Route Template Extraction????3.4 SQ Signal Explorer Expert????3.5 Analysis Preferences????3.6 SigWave????3.7 Delay Measurements 课程进度安排 时间 课程大纲 第二天 9:00|12:00 4 确定和施加约束 Determining and Adding Constrain Solution SpaceAnalysis: Step 1 to 6 ????4.2 Parametric Sweeps.????4.3 Constraints :????????Topology Template Constraints ????????Switc Usage of Constraints Defined in Topology Template 13:30|16:30 5 模板应用和基于约束的布局????Template Applications and Constraint-Driven Placement????5.1 Creating a Topology ????5.2 Wiring the Topology????5.3 TLines and Trace Models ????5.4 Coupled Traces ????5.5 RLGC Matrix of Coupled Trace Models????5.6 Cro Simulating with Coupled-Trace Models????5.8 Sweep Simulation Results with Coupled-Trace Models????5.9 Extracting a Topology Using the Constraint Manager ????5.10 Electrical Constraint Set????5.11 Applying Electrical CSet????5.12 Worksheet Analysis????5.13 Spacing and Physical Rule Sets????5.14 Electrical Rule Set 课程进度安排 时间 课程大纲 第三天 9:00|12:00 6 基于约束的布线 Constraint-Driven Routing ????6.1 Manual Routing????6.2 Routing with the SPECCTRA Smart Route????6.3 Driving Constraints in Routing7 布线后的DRC检查和分析 Post-Route DRC and Analysis????7.1 Post-Route Analysis????7.2 SigNoise????7.3 Reflection Simulation????7.4 Reflection Waveform Analysis????7.5 Comprehensive Simulation????7.6 Cro Cro Simultaneous Switching Noise Simula