bounding the output error in a buck power converter using perturbation theory边界巴克电源转换器的输出误差用微扰理论.pdfVIP

Hindawi Publishing Corporation Mathematical Problems in Engineering Volume 2008, Article ID 732039, 20 pages doi:10.1155/2008/732039 Research Article Bounding the Output Error in a Buck Power Converter Using Perturbation Theory Fabiola Angulo,1 Enric Fossas,2 Tere M. Seara,3 and Gerard Olivar1 1 Departamento de Ingenierıa Electrica, Electronica y Computacion, ´ ´ ´ ´ Universidad Nacional de Colombia, Cra 27 No. 64-60 Manizales, Caldas, Colombia 2 Institute of Industrial and Control Engineering, Technical University of Catalonia, 08028 Barcelona, Spain 3 Departamento de Matematica Aplicada IV, Universitat Politecnica de Catalunya, ` ` 08034 Barcelona, Spain Correspondence should be addressed to Gerard Olivar, golivart@.co Received 20 January 2008; Revised 30 May 2008; Accepted 20 July 2008 Recommended by Oleg Gendelman We show the main results obtained when applying the average theory to Zero Average Dynamic control technique in a buck power converter with pulse-width modulation PWM. In particular, we have obtained the bound values for output error and sliding surface. The PWM with centered and lateral pulse configurations were analyzed. The analytical results have confirmed the numerical and experimental results already obtained in previous publications. Moreover, through an important lemma, we have generalized the theory for any stable second-order system with relative degree 2, using properties related to transformations and stability of linear systems. Copyright q 2008 Fabiola Angulo et al. This is an open access article distributed under the Creative Commons