comparative studies of different control strategies of a dynamic voltage restorer based on matrix converter比较研究不同控制策略的基于矩阵变换器的动态电压调节器.pdfVIP

Hindawi Publishing Corporation Advances in Power Electronics Volume 2012, Article ID 327186, 9 pages doi:10.1155/2012/327186 Research Article Comparative Studies of Different Control Strategies of a Dynamic Voltage Restorer Based on Matrix Converter Amin Shabanpour and Ali Reza Seifi School of Electrical Computer Engineering, University of Shiraz, Shiraz 7134851151, Iran Correspondence should be addressed to Ali Reza Seifi, seifi@shirazu.ac.ir Received 17 May 2012; Accepted 10 September 2012 Academic Editor: Pavol Bauer Copyright © 2012 A. Shabanpour and A. R. Seifi. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. A dynamic voltage restorer (DVR) with no energy storage is studied. By using a matrix converter instead of the conventional AC/DC/AC converters, elimination of the DC-link capacitor is possible. The switching algorithm of matrix converter is the space vector modulation. There are different compensation algorithms to control the conventional DVR. These methods have been analyzed in this paper for the proposed matrix-converter-based DVR. A deep analysis through different diagrams would show the advantages or disadvantages of each compensation method. Equations for all methods are derived, and the characteristics of algorithms are compared with each other. 1. Introduction switches that are able to connect any output phase of the system to any input phase at any time [4]. Some advantages Advanced industrials usually use electronic devices such as o