current mode biquad filter with minimum component count当前模式biquad过滤器计数用最小的组件.pdfVIP

Hindawi Publishing Corporation Active and Passive Electronic Components Volume 2011, Article ID 391642, 7 pages doi:10.1155/2011/391642 Research Article Current Mode Biquad Filter with Minimum Component Count Bhartendu Chaturvedi and Sudhanshu Maheshwari Department of Electronics Engineering, Z. H. College of Engineering and Technology, AMU, Aligarh 202 002, India Correspondence should be addressed to Bhartendu Chaturvedi, f@ Received 26 January 2011; Accepted 28 April 2011 Academic Editor: I. A. Khan Copyright © 2011 B. Chaturvedi and S. Maheshwari. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. The paper presents a new current mode biquadratic filter with one input and three outputs using differential voltage current conveyor (DVCC) and four passive components. The proposed circuit can simultaneously realize low-pass, band-pass, and high- pass filter functions without changing the circuit topology and passive elements. The circuit exhibits a good frequency performance and low-sensitivity figures. PSPICE simulation using 0.5 μm CMOS parameters are given to validate the proposed circuit. The circuit provides a simple yet novel solution to the current-mode filtering after appropriate incorporation of current sensing elements in form of current buffers. 1. Introduction functions are available at once, without any circuit modifi- cation. Moreover, the circuits using grounded components Current-mode circuits have been receiving considerable are benefici