dynamical analysis of long fiber-reinforced laminated plates with elastically restrained edges长纤维增强层合板的动力分析与弹性约束边缘.pdfVIP

Hindawi Publishing Corporation Advances in Acoustics and Vibration Volume 2012, Article ID 189376, 16 pages doi:10.1155/2012/189376 Research Article Dynamical Analysis of Long Fiber-Reinforced Laminated Plates with Elastically Restrained Edges Liz G. Nallim,1 Facundo J. Bellomo,1 Ricardo D. Quinteros,1 and Sergio Oller2 1 INIQUI-CONICET, Facultad de Ingenier´ıa, Universidad Nacional de Salta, Avenue Bolivia 5150, 4400 Salta, Argentina 2 International Center for Numerical Method in Engineering, (CIMNE) Technical University of Catalonia-Barcelona Tech (UPC), Edif. C1, Campus Nord, Jordi Girona 1-3, 08034 Barcelona, Spain Correspondence should be addressed to Liz G. Nallim, lnallim@.ar Received 30 December 2010; Revised 7 August 2011; Accepted 14 September 2011 Academic Editor: Kok Keong Choong Copyright © 2012 Liz G. Nallim et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This paper presents a variational formulation for the free vibration analysis of unsymmetrically laminated composite plates with elastically restrained edges. The study includes a micromechanics approach that allows starting the study considering each layer as constituted by long unidirectional fibers in a continuous matrix. The Mori-Tanaka method is used to predict the mechanical properties of each lamina as a function of the elastic properties of the components and of the fiber volume fraction. The resulting mechanical properties for each lamina are included in a general Ritz formulation developed to analyze the free vibration response of thick laminated anisotropic plates resting on elastic supports. Comprehensive numerical examples are computed