注塑机专业英语.docVIP

钣金 machine cover / upper cover/ side cover锁模部分 clamping unit射胶部分 injection unit机架 machine frame / base电气系统 electric system液压系统 hydraulic system机械系统 mechanical system机门 safety door / fixed door / movable door锁模部分 clamping unit电脑控制器 computer controller机械安全锁 mechanical safety interlock射胶部分 injection unit液压系统 hydraulic system电箱 electrical cabinet / cable机架分体线 stand split line机架螺丝孔 foundation bolt hole机架 machine base / supporting frame理论注射容积 theoretical shot volume实际注射量 shot weight螺杆直径 screw diameter注射压力 injection pressure注射速度 injection speed注射速率 injection rate螺杆长径比 screw L/D ratio螺杆行程 screw stroke螺杆转速 screw speed熔胶能力 plasticizing capacity锁模力 clamping force开模/锁模行程 mold clamping / opening stroke模板尺寸 platen size拉杆间距 distance between tie bars / rods模板最大距离 max. daylight容模量 mold thickness (min. max.)顶出行程 hydraulic ejection stroke顶出力 hydraulic ejection force顶针数 nos. of ejector pin液压系统压力 hydraulic system pressure油泵马达 pump motor电热量 heating capacity温度控制区数 nos. of temp control zones射嘴接触力 nozzle contact force ? ? ? Injection??????? 射出 Cooling time? 冷却时间 Holding time?? 锁模时间 Injection alarm time? 射出警报时间 Injection start delay Final cushion minimum value Change-over to holding by value Plasticizing end value Hydrarlic change-over pressure holding Screwvalue for change-over to holding Change-over to holding by enable value Hydraulic pressure in holding?? 锁模压力 Filling stage pressure limit Injection speed??? 射出速度 Injection注射 Cooling time冷却时间 Holding time Injection alarm time注射报警时间 Injection start delay注射开始延时 Final cushion minimum value最后段位置 Change-over to holding by value切换到锁模 Plasticizing end value预塑重终点 Hydrarlic change-over pressure holding切换到保压 Screwvalue for change-over to holding加料 Change-over to holding by enable value Hydraulic pressure in holding锁模力 Filling stage pressure limit充模压力 Injection speed注射速度 Plasticizing delay预塑延时 1st suck-back speed储料一速度 1st suck-back pressure储料一压力 Screwrotation speed螺杆转速 Decompression value at end of injection注射