高效发电（Efficient power generation）.docVIP

高效发电（Efficient power generation） Pilot report on power generation of high efficiency low temperature heat source power cycle unit First, the basis and scientific significance of standing questions In two Chinas important energy power production, consumption of large quantities of coal, power generation efficiency is not high, such as thermal power generation in 2006 total: 23573 kwh of coal by 22.1 tons of standard coal, power generation efficiency of about 18-25% according to the digital calculation of , and CO2 SO2 emissions about 6000000000 tons, 0.9 tons, serious ecological pollution the environment. Moreover, as the fossil energy crisis is approaching, people have to work hard to improve the efficiency of electricity production, developing alternative energy, all currently used in thermal power generation units in China with water as the refrigerant steam turbine, are based on the cycle and Rankine cycle design of Kano, to improve the efficiency of power generation with high temperature and high pressure solution is close to limit. Limited by the temperature, the efficiency is more than 30% - 40%. The existing power generation enterprises have about 50% heat energy (from the 20 chapter of the Handbook of thermal engineering, seventh pages), which distribute in the air, and the main part is in the condensing tower and flue gas. This pilot project is different from the above two cycles, with critical temperature of refrigerant C3F8, and organic compounds containing fluorine as the starting point, the working medium is special equipment for vaporization temperature increasing, increase the temperature and pressure range of modern automatic control technology for real-time control, the refrigerant gas through the turbine adiabatic expansion after just to the critical temperature, pressure, condensing heat released minimum refrigerant, then through the booster pump according to the main control room of NC instructions into quantitative carburetor, completing the cy