放电等离子烧结cu-ysz复合材料的显微组织表征和干滑动摩擦行为 microstructural characterization and dry sliding wear behavior of spark plasma sintered cu-ysz composites.pdfVIP

Trans. Nonferrous Met. Soc. China 26(2016) 1745− 1754 Microstructural characterization and dry sliding wear behavior of spark plasma sintered Cu−YSZ composites Jafar MIRAZIMI, Parvin ABACHI, Kazem PURAZRANG Department of Materials Science and Engineering, Sharif University of Technology, Tehran, P. O. Box 11155-9466, Iran Received 9 August 2015; accepted 5 February 2016 Abstract: In the present study, yttria stabilized zirconia (YSZ) reinforced Cu matrix composite specimens were produced by spark plasma sintering (SPS). For comparison, pure Cu specimen was also produced in the same conditions. The effect of particles content on microstructure, relative density, electrical conductivity, and Vickers hardness was evaluated. The pin-on-disk test was also performed to determine dry sliding wear behavior of specimens under different wear conditions. After sliding wear tests, the worn surfaces were examined by field emission scanning electron microscopy (FE-SEM). Microstructural study showed satisfactory distribution of reinforcement particles in copper matrix. The relative density up to 95% was obtained for all specimens. By increasing YSZ content from 0 to 5% (volume fraction), the electrical conductivity of specimens decreased from 99.2%IACS to 65%IACS, correspondingly. The hardness of Cu−5%YSZ composite specimen was two times greater than that of pure copper. The volume loss 3 −3 3 and wear rate of pure Cu specimen were 1.48 mm and 1.5×10 mm /m under 50 N applied load and 1000 m sliding distance.