explore the plate evaporative air cooler unit in the application of methyl ethyl ketone（探索板式蒸发式空气冷却器单位甲乙酮的应用）.docVIP

Explore the plate evaporative air cooler unit in the application of methyl ethyl ketone Currently, methyl ethyl ketone de-butene unit E-008 tower air cooler in the summer each year has been the SBA-butanol production of synthetic crude Section of the ‘bottleneck’, thereby affecting the production of methyl ethyl ketone. While the existence of inspection maintenance difficult air-cooled, frost and other shortcomings of anti-coagulation is difficult, therefore, it is necessary to explore through the air cooler, and the investigation and evaluation, and reliable design, the air cooler to be transformed into full-load air-cooled to run, to improve butanol synthesis section in the output of crude SBA, and to ensure long-term operation. Methyl ethyl ketone 1 is currently installed in the air cooler E-008 with defects 1.1 limits the production of methyl ethyl ketone Summer air-cooled six wind turbines in full operation, blinds fully open state, still can not meet the production to the thus reduced to the amount of butene-loop two-thirds of the original when the amount of butene to increase the maximum cycle time, E-008 After the cold temperatures will exceed the technical requirements of 64 ℃, to 70 ℃, the amount will continue to raise serious cause butene butene loop back off the tank V-102 and C-101 operations butene tower fluctuations, while in winter the amount of butene-cycle can maintained at 66t / h. After cooling for summer high temperature limit production of MEK, the workshop to take on the E-008 air cooler tubes spray, it is a blast type, a strong flow of hot air swept away most of the cooling mist , would not achieve significant cooling effect, and one spray of water to accelerate the air cooler outer wall of the finned tubes and steel corrosion and scaling, seriously affect the long-term running cooler. 1.2 the presence of corrosive leak As the water entrained chloride and sulfate ions, the formation of a point in the wall of the acid s