汽机联锁条件检查表 -V7.doc

  1. 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
汽机联锁条件检查表 -V7

哥伦比亚GECELCA 3燃煤发电站项目 Colombia GECELCA 3 Coal-fired Power Station Project 汽机联锁保护试验表 A catalogue of turbine interlockprotections Document Title : 汽机联锁保护表 A catalogue of turbine interlockprotections GECELCA3 四川省电力工业调整实验所 Si Chuan Electric Power Commissioning Test Institute Document No. Revision Released by (date/signature) Compiled: Checked: Approved: Released: 目 录 凝结水系统Condensate water system 3 电动给水泵系统Motorized feedwater pump system 9 真空系统 Vacuum system 18 润滑油系统 Lube oil system 22 EH油系统 EH oil system 24 除氧系统 Deaerator system 26 高加系统 HP heater system 30 低加系统LP heater system 36 主再、疏水系统Main steam、reheat steam and drainage system 45 轴封系统Shaft seal system 50 顶轴油盘车系统Jacking oil turning device system 51 DEH、ETS跳闸保护DEH, ETS tripping protection 53 旁路系统Bypass system 56 循环冷却水系统Circulating cooling water system 59 机械冷却塔系统Mechanical Draught Cooling tower system 68 凝结水系统Condensate water system 序号 No. 试验内容 Test Content 检查日期 Inspection date 试验结果 Test result 运行 Operation Contractor 川调 SCCTI 监理 Supervision Contractor 备注 Remarks #1凝结水泵启动允许条件检查 Inspection of startup permissive conditions of #1 condensate pump 1、凝泵电机定子线圈温度不高 1、Condensate pump motor stator winding temperature not high <115℃ 2、凝结水泵推力轴承温度不高 2、Condensate pump thrust bearing temperature not high <75℃ 3、电机上轴承温度不高 3、Motor upper bearing temperature not high <85℃ 4、电机下轴承温度不高 4、Motor below bearing temperature not high <85℃ 5、凝汽器热井水位不低 5. Hot well water level of condenser not low #1凝结水泵保护跳闸条件检查 Inspection of protective tripping conditions of #1 condensate pump 1、凝泵电机线圈温度高高 1. Condensate pumps motor coil temperature HH ≥120℃ 2、凝结水泵电机上轴承温度高高 2. Condensate pumps motor upper bearing temperature HH ≥90℃ 3、凝结水泵电机下轴承温度高高 3、Condensate pump’s motor below bearing temperature HH ≥90℃ 4、凝结水泵推力轴承温度高高 4、Condensate pumps thrust bearing temperature HH ≥80℃ 5、泵启动,出口门仍是关信号 . After pump startup, it is still Close signal at outlet valve Delay 10s 6、凝汽器热井水位

文档评论(0)

dajuhyy + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档