沉箱回填（Caisson backfill）.docVIP

沉箱回填（Caisson backfill） Proper method of filling caisson toilet Light filling technology in toilet First, the craft Name: toilet light backfill Two 、 scope of application: caisson type toilet Three, process characteristics: Backfill light, no damage to the pipeline Four, the use of materials: cement, ceramsite, phi 6 rebar, wire grid Five, use tools: spades, ash knives Six, construction sequence: Clean up and fixed into a drainage pipe caisson, ceramsite and cement mixing, compaction, filling with iron wire mesh leveling Seven, operating rules: 1. before the light backfill is carried out, the caisson shall be cleaned and the water inlet and outlet pipe shall be secured so as to avoid touching the pipe in the backfill. 2. the proportion of ceramsite and cement is recommended as 5:1. 3. the bottom to make two drainage water using ceramsite, according to the box base or intermediate to two emissions drain. 4. caisson backfill is about 4/5, about 30mm-60mm cement mortar leveling, compaction to. If placed in the bathtub, must add phi 6 bars made of 20cm grid. The last 5. plus barbed wire with 1:3 cement mortar leveling, put the slope as a waterproof base. Eight, quality requirements: 1. pipe fixed, firm. 2., the proportion of ceramsite and cement should be accurate, add water accurately, mixing evenly. 3. the wire mesh joint shall overlap over 100 mm. Nine, matters needing attention: 1. press tight, but dont step on the pipe. Two Backfill should be dense. 3., wire and cement mortar to be integral, pay attention to cement mortar to find the usual slope. 4., pay attention to the ground floor elevation of the toilet, should not be higher than the aisle or room floor. 66 2009-10-20 12:58 Ceramsite can also use light brick instead of, but can not be used instead of bricks, bricks for free to fill more wrong. The principle of backfill is light weight and does not damage the pipe. 66 2009-10-20 14:05 Step 1: do two times waterproof coating, these two times waterproof must be don