过程装备与控制工程专业毕业(设计)论文外文资料翻译.doc

外文资料翻译 资料来源： 文章名：书名：《》 作 者出版社：章节：页码：1002050306 指导教师(职称)： 郑小涛 专 业： 过程装备与控制工程 班 级： 10过控03班 所 在 学 院： 机电学部 外文原文: Experimental Study of Shell-Side Heat Transfer Coefficient and Pressure Drop for an Integrally Helical Baffled Heat Exchanger Combined with Different Enhanced Tubes Zhengguo Zhang *?, Changshun Wu ?, Xiaoming Fang ?, Xuenong Gao ? and Zhenyong Wang ?? School of Chemistry and Chemical Engineering, South China University of Technology, Guangzhou 510640, China, and Technology Engineering Center, Foshan KAMUI Heat Exchanger Co., LTD, Foshan 528000, China Ind. Eng. Chem. Res., 2009, 48 (8), pp 4040–4044 DOI:10.1021/ie801339s Publication Date (Web): March 19, 2009 Copyright ? 2009 American Chemical Society South China University of Technology. Foshan KAMUI Heat Exchanger Co. Abstract Experiments were performed to compare the shell-side heat transfer coefficient and pressure drop of an integrally helical baffle heat exchanger with rib-shaped fin tubes to those of that with low-fin tubes for oil cooling using water as a coolant. The experimental results showed that for the heat exchanger with rib-shaped fin tubes, the shell-side Nusselt and Euler numbers were augmented by 90?130% and 10%, respectively. The increase in heat transfer is significantly greater than that in pressure drop for rib-shaped fin tubes. Correlations have been suggested for both the shell-side Nusselt and Euler numbers for the two heat exchangers with different tube types and give very good agreement with experimental results. It is a promising route to use rib-shaped fin tubes instead of low-fin tubes for improving the performance of an integrally helical baffle heat exchanger. 1 Introduction Heat exchangers are used in several industrial processes, such as refinery, ethylene, gas treatment, gas liquefaction, and polymer and power generation. The conventional shel