基于ANSYS的深孔多孔件钻削加工刀具寿命分析.PDFVIP

34 2 Vol.34 No.2 () 2013 3 Mar. 2013 JournalofJinggangshanUniversity (NaturalScience) 82 82 () 1674-8085(2013 ANSYS * 1,2 2 1. 2410002. 230009 ) Ansys10 TG659 A DOI:10.3969/j.issn2013.02.019 库 BASED ON THE ANSYS DEEP HOLE AND POROUS WORKPIECE OF DRILLING TOOL LIFE ANALYSIS 例 *WEI Ping1,2HAN Jiang2 1.Anhui Technical College of Mechanical and Electrical Engineering, Wuhu, Anhui 241000, China; 案 2.HeFei University of Technology, Hefei, Anhui 230009, China ) E Abstract: Based on the analysis of typical products, the typical product development process was studied and A analyzed. In the continuous experiment and practice, some processing methods of key problems were obtained. C Aiming at low processing efficiency characteristics of the deep hole, small hole and the porous member field, if through the test methods, it would be waste materials and time. Based on the ANSYS software, we analyze the 模 general twist drill mode, thermal stress, static structure, dynamic model, the optimization of cutting parameters to solve before processing, improve processing efficiency, save cost. Key words: deep hole drilling; finite element analysis; drilling process; optimization of cutting parameters 凯 O 0 E M