灯饰检验标准.doc

A. Inspection Standard(验货标准)  General QA Standard Page 1 of 8 Unless otherwise stated. QC should use the following sampling plan and AQL (Acceptable quality Levels) 除非客人有特别要求QC将采用下列AQL验货标准: Critical defect :0% Major defect :2.5% Minor defect :4.0% B. Drop Test Standard(试摔测试标准) Drop test is applicable for all items. QC will select 3 master carton from the shipment hold the master carton ITEM,QC将从大货中抽取3箱做测试 in a horizontal position, pointing the testing panel to the concrete floor. 水平向地面进行做测试 test will repeat the test for each of the six faces,3 sides and 1 corner of the master carton. 测试为六面,三条边,一个角 pls refer the following table for the appropriate height. 测试高度请参考如下表格  Gross weight of master carton 外箱毛重 0 ~ 9.5 kgs 45.3 ~ 68 kgs Height from bottom of master carton to floor 外箱底部离地面高度 30 inches 24 inches 18 inches 12 inches 8 inches  If the damage rate exceeds 10%,QC will recommend the factory not to release the shipment and explore ways to modify the package, However, the final disposition decision should be made with our QC manager. 如果损坏率超过10%,QC将提出不放行货物并与工厂讨论如何修改方案.最终由QC经理决定. C. Shade Styrene Standard(灯罩塑胶板标准) Thickness of the Styrene for lamp shade with shade size 5x 10x 7 or below needs 0.33mm 灯罩尺寸5 x 10 x 7或以下尺寸时,须用0.33mm厚的塑胶板. Thickness of the Styrene for lamp shade with shade size 5 x 10x 7 or over needs 0.35mm 灯罩尺寸5 x 10 x 7或以上尺寸时,须用0.35mm厚的塑胶板. D. OPP Standard(OPP标准) Appropriate width of the OPP wrap should be used for different shade size. Criteria for the shade after wrapped by the OPP wrap need to be: OPP包装的宽度会因灯罩尺寸不同而使用不同,标准灯罩包装OPP包装必须如下: 1. Shade to be totally covered by the OPP wrap without loosed end, Shade need to look neat and tidily after wrapped and style of the shade could be clearly visible after wrapped. 灯罩OPP包装要紧不可松动,灯罩要保持干净,能清楚的看见灯罩的类型. 2. No excess crinkle of the OPP wrap on the top part of shade. 灯罩顶部不可以有过多的皱折. E. Lead Contents Standard(含铅量标准) all products must be used low lead contents requirement( 90PPM/0.