一种大间距锯齿翅片的实验和数值研讨.pdf

中国工程热物理学会 传热传质学 学术会议论文 编号：093161 一种大间距锯齿翅片的实验和数值研究 周国晗 凌 祥 （南京工业大学机械与动力工程学院，南京市鼓楼区丁家桥五号，210009 ） 联系电话025 Email ：guohanzhou@ ；xling@ 摘 要: 以空气为介质，在搭建的风洞的试验台上，对一种可用于冷凝式烟气余热回收的大间距不锈钢 锯齿翅片的传热和流动性能进行了实验研究，取得了该翅片的Re-j 和Re-f 曲线，并通过CFD 方法对 翅片性能进行了数值模拟，两者对比表明，数值结果与实验结果吻合的较好。在此基础上，研究了流 体进口流速对对传热流动性能的影响，为冷凝式烟气余热回收的不锈钢板翅式换热器的优化设计提供 依据。 关键词：冷凝式 余热回收 不锈钢锯齿翅片 数值模拟 传热性能 Numerical modeling and experimental study on flow and heat transfer performance of a serrated fin of large fin pitch ZHOU Guohan ，LING Xiang ( School of Mechanical and Power Engineering，NanJing University of Technology ，Nanjing 210009 ，China ) Abstract: The flow and heat transfer performances of a stainless steel serrated fin which is used for condensed waste heat recovery was investigated experimentally and the cuvres of Re-j and Re-f are obtained in this paper. The experiments were performed on the wind tunnel systems and with the air as the medium,.A CFD method also be used to simulate the performances of the fin surface. The numerical results show good agreement with the experimental data. Based on this, the effect of inlet velocity on heat transfer performance is presented and discussed, , the results can be referenced for the optimal design of the fin plate exchanger of condensed flue gas waste heat recovery . Keywords : Condensation; waste heat recovery; stainless steel serrated fin; numerical simulation; heat transfer performance 0 引言 现今我国中小型锅炉数量众多，而大部分锅炉产生的高温烟气直接排放到环境中 去。这些烟气携带了大量的汽化潜热，直接排放不仅极大的浪费了能源，也增加了污染 物的排放，因此采用冷凝式换热器将高温烟气中的显热和潜热进行回收，可以降低烟气 [1~4] 的排放温度，有效的回收余热和废热，在能源紧缺的今天显得十分重要 。 板翅式换热器是一种高效、紧凑