铝及钢卷装箱要求.pptVIP

Technical Guidelines for STEEL COILS in ISO Containers Loading Instructions Only 30 tonnes tested 20’ containers to be used. The steel coil must have NO CONTACT WITH THE FLOOR of the container. Weight per metre (linear) = 5 tonnes max. Support for the steel coil: there has to be a support (example; timber or steel beam) and the ‘support’ contact area must allow pressure of maximum 5 tonnes / metre (linear) Coil Loading Guidelines …… The coil must be secured good inside the container. The steel coil can cover the max payload of the container only if the coil’s weight is distributed proportionally in the container (Max 5 Tonnes/ Linear Metre). Placement of Coils: Eye to Sky Small and Narrow coils can be placed like drums close to each other. For security, bind them together with steel straps or block them with wood. This will not pose a problem to the container structure if the bottom of coils is evenly loaded over its fill length and width. Placement of Coils:Eye to side Distribute coils over the full floor area, so that the centre of gravity is in the middle of the container lengthwise and across. Avoid pressure on side walls. Proper bedding,lashing and blocking sideward and to the door side is necessary. Placement of Coils:Eye fore and aft Accepted securing Picture for Non Acceptable Damages due to coils Damages due to coils Repair Estimate Example Shipper’s Responsibility To fully indemnify for any damages and/or losses that may be sustained by the containers/equipment used for the loading of Steel coils. To pay for the repair costs/replacement values ascertained upon first demand. The replacement values will be deemed accepted upon provision of the Depreciated Value issued by CMA CGM The repair costs will be deemed accepted upon provision of the Estimate Repairs Forms issued by CMA CGM Authorized depots/company. To fully indemnify for any claim for consequential direct or indirect damages or losses that may be caused by the Steel Coils.