孤板式电选机使用及操作 - spiral chute, spiral .docVIP

弧板式电选机使用及操作 说明书 弧板式电选机使用及操作 User Manual of Arc-Plate Style Electrical Sorting Machine 一、简介（Introduction） 弧板式电选机是在溜板式电选机和筛板式电选机的基础上改进研制的新式选矿设备，具有耗能小、产量大，易操作等优点，适用于澳州、印尼、越南等地区的锆英石、金红石、锡矿石等稀有金属矿的扫选及精选。 Arc-Plate Style Electricity Sorting Machine is the new type of mineral processing equipment based on the improvement of Slide-Plate Style Electrical Sorting Machine and Sieve-Plate Style Electrical Sorting Machine. It has the characters of low energy consumption, large output, easy operation, etc. It adapts to the selection of rare metal ore, such as zircon, rutile, tin ore which distribute in Australia, Indonesia, Vietnam and so on. 二、工作原理及结构（Structure and working principle） 本机采用双排四层结构，每层都有接地弧形溜板（无锈钢制），其上部安装一弧状带高压静电板（铝板制），此电极板固定不动（但可调），在接通高压静电后，矿物经下矿板溜至接地弧板进入高压电场区，导电矿物被感应而带电，吸向电极，但由于受到重力作用，故它的运动轨迹不同于非导体矿而从前方排出，非导体矿也受到电场作用，但不会被吸引而进入下层再分选，复选四次直至矿产品合格。 This machine has the structure of two rows and four stories in each row. Each floor has an earthing curved slide board (stainless steel). On the top it has an arc-shaped high-voltage electrostatic plate (aluminum), which is stationary (but adjustable). When connected to high voltage static electricity, the ore minerals slip into high-voltage field area via earthing arc plate, then conductive minerals charged by induction and attracted to the electrode. Due to gravity, it is discharged from the front which is different from the non-conductive ore. Meanwhile, non-conductive mineral has also been affected by the electric field, but will not be attracted into the lower re-sorting. The process will be conducted for four times until the minerals are qualified. 三、安装（Installation） 1、本机配有底架，安装时要求垂直放置。 2、接地要良好，地线要用铜管或角钢、水管在室外潮湿处深埋2～3米。 3、高压电缆安装时最好套在塑料管内，以防漏电。 4、矿仓加热导线要选用4.5mm2电缆，本机控制柜里设有高、低温开关。 1. The machine is equipped with chassis and it should be placed vertically when installed. 2. It should be grounded well. The ground line should be buried with angle iron or water pipe into a 2-3 meters wet underground place. 3. High-voltage