基于永磁定位技术的三维腿部运动检测系统设计.pdfVIP

RESEARCH WORK 论 著 基于永磁定位技术的三维腿部运动 检测系统设计 张可，汤福南，李修寒，吴小玲 南京医科大学生物医学工程系，江苏南京 210029 [摘 要] 目的 设计一种基于永磁定位技术的三维腿部运动检测系统，实现对腿部运动的实时显示。方法 首先，在腿部关节 点佩戴3轴磁传感器，小磁体佩戴在与其连杆的肢体上，两者距离约6 cm。磁传感器检测该小磁体的磁感应强度，并对采集 到的信息进行多级放大、滤波处理，通过串口发送至上位机。其次，编写上位机程序。利用Labview软件处理接收到的电压 信号，还原为磁感应强度信号，并通过PSO与LM算法结合进行磁源定位。最后，加载三维腿部骨骼模型，实现直观的三维 实时显示。结果 磁传感器检测范围实验显示，小磁体与磁传感器之间距离设置为6 cm时，既可满足磁偶极子模型，又对临 近组传感器无影响。小磁体3轴定位平均误差在1 cm之内，整个系统完成一次完整的数据采集约耗时17.5 ms，基本满足实时 性的要求。三维腿部运动检测实验显示，实验结果与被测者腿部姿态基本一致。结论 基于永磁定位技术的三维腿部运动检 测系统能够实现三维腿部运动检测功能，为步态检测及腿部康复训练提供了一种新方法。 [关键词] 运动检测；永磁定位；三轴磁传感器；定位算法 Design of a Three-Dimensional Leg Motion Detection System Based on Permanent Magnet Positioning Technology ZHANG Ke, TANG Funan, LI Xiuhan, WU Xiaoling School of Biomedical Engineering, Nanjing Medical University, Nanjing Jiangsu 210029, China Abstract: Objective To design a kind of three-dimensional leg motion detection system based on permanent magnet positioning technology to achieve real-time display of leg motion. Methods Firstly, the three-axis magnet sensors were placed on the leg joints, and the small magnets were placed on the limbs which were connected to the leg joints, while the distance between the sensor and magnet was about 6 cm. The sensors were used to detect the magnetic induction intensity. The signal was gradually exaggerated and filtering processed, and was sent via the serial port to PC. Secondly, the magnetic induction intensity of the signal was converted into a voltage signal by LabVIEW software, and the voltage signal was combined with LM algorithm and PSO algorithm and was used for magnet source localization. Results The experiment for detection range of Magnetic sen