装修专项施工方案.docVIP

Construction Plan 施工方案 Construction Plan 施工方案 Section 1.0 Plasterboard Partition on Metal Stud 第一节 轻钢龙骨隔断施工方案 1.1 Requirement of Materials, Components and Fittings 材料及构配件要求 Each kind of stud, fittings and surface materials should accord with the current requirement. Re-testing will be conducted when more than 500 square meters man-made boards are used. Provide test report of TVOC and formaldehyde for water-based adhesive. 各类龙骨,配件和罩面材料及胶粘剂的材质应符合现行要求.人造板材使用量大于500平米时应进行复检;水性胶粘剂必须有TVOC和甲醛检测报告。 Filled with insulation material: The glass wool, rock wool, etc. should be consistent with the design requirements 填充隔音材料:玻璃棉,岩棉等应符合设计要求。 1.2 Main Equipment and Tools 主要机具 Electrical machine tools: Electrical saw, Hand-held electric drill, impacting drill, DC welding machine, and cutting machine 电动机具:电锯,手电钻,冲击电钻,直流电焊机,切割机。 Manual tool: manual saw, pliers, riveter, screwdriver, level and steel level 手动工具:手锯,钳子,拉铆钳，螺丝刀,靠尺,钢水平尺。 1.3 Metal Stud Installation 龙骨安装 The type, size, color of the materials and the structure fixing method of the partition should comply with the design. 隔断工程应用材料的品种、规格、颜色以及隔断的构造固定方法应符合设计要求。 As per the drawings, setting lines on the cleaned floor for the wall locating and drawing out the locations of doors, windows and preformed openings. 按图纸要求，在清洁干净的地面上放墙位线定位，并标出门、窗及预留孔位置，确定墙体位置 Install the top and bottom studs at the wall location, screws shall be used to fix the studs and the space between screws is 600mm 在墙体位置上安装沿地、沿顶龙骨，固定龙骨采用螺钉固定，螺钉间距为600mm。 The vertical studs will be installed into the top and bottom studs, adjusting the dimensions and verticality, the vertical studs by the walls will be fixed by screw every 800mm and the other vertical studs by rivets. When the studs located at doors, windows and the preformed openings, additional studs will be added and to be fixed by rivets. 竖向龙骨的上、下两端插入沿地、顶龙骨，按要求调整尺寸，放垂直，靠墙两边的竖龙骨，用螺钉将其固定，钉距800mm，其它龙骨采用抽心铆钉固定。但当龙骨位置在门口、窗口或其他预留孔时，主要加撑并用铆钉固定。 1.4 Gypsum Board 石膏板安装 nstallation 安装 The gypsum board should be