×MW热电厂电气部分设计本科毕业论文.doc

2×350MW热电厂电气部分设计本科毕业论文 2×350MW热电厂电气部分设计 摘 要 发电厂是电力系统的重要组成部分, 也直接影响整个电力系统的安全与运行。在发电厂中,一次接线和二次接线都是其电气部分的重要组成部分。 本文为规划4×350MW热电厂的一期工程2×350MW热电厂电气部分设计,通过对拟建火力发电厂的概括以及出线方向来考虑,并通过对负荷资料的分析,从安全性、经济性及可靠性方面考虑,确定了220kV以及厂用电的主接线,然后通过负荷计算及供电范围确定了主变压器台数、容量及型号,同时也确定了厂用变压器的容量及型号。最后,根据最大持续工作电流及短路计算的结果,对高压断路器、隔离开关、母线、绝缘子、穿墙套管、电压互感器、电流互感器进行了选型,从而完成了2×350MW热电厂电气部分设计。 2 x 350MW power plant electrical design Student: Zhang LinglingInstructor: Zen Zhongfan Keywords: Power plant Power system AbstractPower plant is an important part of power system, but also directly affect the safety and operation of power system. In the power plant, a wiring and the two wiring is the important part of the electrical part In this paper, for the planning of 4 × 350MW thermal power plant project phase 2 × 350MW for the electric part of power plant design, to consider the coal-fired power plant and the wire direction of generalization, and through the analysis of load data, from the consideration of safety, economy and reliability, determine the main wiring of electrical 220kV and factory, and then the number, capacity and model of the main transformer is determined by the load calculation and scope of supply, but also determine the factory transformer capacity and models. Finally, according to the calculation of the imum continuous working current and short circuit of the results, the high-voltage circuit breaker, isolating switch, bus, insulator, bushing, voltage transformer, current transformer is selected, thus completing the 2 x 350MW power plant electrical design. 2×350MW热电厂电气部分设计 目 录 1.前言 1.1电力系统概述 1.2电力工业的发展概况 1.3我国电力行业发展方针 1.4毕业设计的主要内容及基本思想 2. 电气主接线 2.1电气主接线概述 2.2对原始资料的分析 2.3拟定可行的主接线方案 2.4厂用电的设计 3. 短路电流的计算 3. 1短路计算的目的 3. 2短路电流计算的条件 3.3短路电流分析 4.主要电气一次设备选择 4.1 概述 4.2 高压断路器的选择 4.3 隔离开关的选择 4.4 母线的选择 4.5电流互感器的选择 4.6电压互感器的选择 单元变、启动变容量校核 5.1 导言 变压器容量应满足的要求 5.3、计算依据 5.