桥梁浑河大桥的设计.docx

PAGE \* MERGEFORMAT 95密级： 密级： 浑河大桥设计Hunhe Bridge Design学 院：建筑与土木工程学院专 业 班 级：学 号：学 生 姓 名：指 导 教 师： （讲师）2015年 06月摘 要根据任务书的要求，我们需要设计一个跨河桥梁的现浇预应力混凝土连续箱梁桥在沈阳市。连续箱梁桥的设计分为5个，其中长90m的两侧，主跨长140m，桥梁长度600m。按照任务书的要求，采用整体双向六车道。本设计主要通过桥梁，整个施工过程仿真软件，以及静载桥，活荷载和内力的分析与计算。在使用桥梁博士施工模拟，第一步是分区全桥单元根据承载能力极限状态和正常使用极限状态的软件桥梁博士和比较输出，然后选择一个更大的值的配筋计算。根据配筋结果，进行钢束的输入和整个施工过程仿真。然后根据有关规定“公共预调节，负载，预应力，等。桥梁博士进行拟定验算后，就可以根据《公预规》的相关规定，对于桥面板上进行铺装，并且对桥面进行验算和配筋的计算。其次，还要根据桥梁博士中对于桥梁上部结构验算，求出支座反力，根据墩台支座反力选取相关规格的支座。最后进行桥墩桥台的配筋以及基础的设计，一般选用有盖梁连接的柱式支座。对“公共预规”有关规定计算后，医生可以进行桥梁的桥面铺装，和桥面板计算校核计算。其次，即使按照桥梁博士对支座反力桥梁上部结构的计算，根据墩支座反力的相关规格轴承选择。桥梁墩台加固的最终设计，基础，梁柱一般选择支持连接。关键词：预应力； 箱型桥梁；荷载。Abstract According to the requirements of the task book, we need to design a bridge is now a prestressed concrete continuous box girder bridge moat in Hunhe River in Shenyang. This continuous box girder bridge design is divided into two aspects, and three of the medium span, both sides are 90m long, and the main span length 140m. So the length of the bridge is 600m. According to the mission requirements, the bridge is the main road in the suburbs, so the overall two-way six lane.Single box chamber fulcrum beam 8 meters high, span variable cross section, beam height of 3.5m, deck wide 19m. Through 3,75m single lane width, pavement width of 2m, right shoulder 2.5m, guardrail is 0.5m.This design is mainly through the simulation of the whole construction process of the bridge, and the bridge, the static load, live load and internal force analysis and calculation. In, using the bridge construction simulation, the first step is partitioning the whole bridge unit according to the bearing capacity limit state and normal use limit state results software doctor bridge and compare the output, choose a larger value of the reinforcement calculation. According to the results, it is carried out. The input and construction of the steel beam are simulated and then the relevant provisions of the relevant provisions of the load, pre