对绞吸式挖泥船绞刀切削岩土的数值分析-地质工程专业论文.docxVIP

华北水利水电大学硕士学位论文 华北水利水电大学硕士学位论文 目录 目录 万方数据 万方数据 万方数据 万方数据 NUMERICAL ANALYSIS OF CUTTING PROCESS FOR CUTTER SUCTION DREDGER WHEN CUTTING GEOTECHNICAL ABSTRACT Drdeger is an important tool in the dredging engineering. In various drgeders, cutter suction dredger is widely used, and in which cutter is the key component. Based on the 3D modeling of the cutterhead, we analyzed the soil cutting process. Also, we carried out the cutting force calculation through 2-D soil-cutting theory and the stress analysis of cutterhead by finite element software of Ansys. Firstly, 3D modeling of the cutterhead was built by software of Catia. However, missing of line and plane occurred when we importing the 3D modeling into Ansys. Delightedly we solved the problem by using Pro/E software. Then, cutting force analysis was carried out based on 2-D soil-cutting theory. The cutting processes and cutting forces of the cutter for different envelop angles were calculated. Finally, the strains and stresses of the cutterhead were calculated by Ansys based on 3D modeling of the cutter. We only analysed the cutter blade which participated in the cutting processes. Our treatment is similar to the practical situation in construction, and the calculation results are reasonable. And through the 2-D soil-cutting theory we can get in the same geological condition and at the moment of 15degrees the cutting power and the efficiency are the highest. But at the moment of 30degrees the cutting power and the efficiency are the lowest. In this paper, we analysed the strains and stresses of the cutter blade which participated in the cutting processes with actual geological data by Ansys and provided a method for realistic cutting processes simulation. KEY WORDS:Reamer; Three-dimensional modeling; Cutting process;Ansys software; Stress-strain II 目 录 摘 要.............................................................................................................................. I HYPERLINK \l _bookmark0 ABSTRACT...