高分子复合材料摩擦磨损性能研究-机械工程专业论文.docxVIP

硕士学位论文Abstract 硕士学位论文 Abstract As a la穆e scale capacity for petro-chemical unit production，the enterp订se has increaged the d印eIldence for dynamic equipment During productjon，because of the reasons for design， manufacturing卸d material property，the fault rate for equipment is stilI high，especially for the fa订ure of components caused by wear and it is also a very common failure．This topic has used a reciprocating铺ction eXperiment machine made by Machineelectricity in吼ituIte of Lanzhou IndustriaI university，we have taken some wearing experiments for these four hi曲 p01ymers anti-wearing materials— Polynuonetraethylene， Nylon 1010， Polynuortetraethylene with fiIling of graphite and PoIynuortetraethylene with filIing polystyrene，which are widely used for manufactLlring a supportmitigation piston ring for reciprocating compressing machine in petm-chemical industry Aner stud y，we find that although nylon 1010 has a better anti-wearing property and a small行iction coemcient，it only can be used for smalI and 10w pressure compressorbecause the Heat warps is lower These poly—matefials，Polyfluonetraethylene whh filling of Graphite a11d Ekonol，can e行cctively improve the property ofPoIyfluorte仃ae-thylene．The hardness of P01y—material is increased，the仔iction coe捕cient reduced，Line expanding coe踊cient reduced Especially for P01yfluortetraethylene aner fi Jling ofEkonol，the hardness is obviously increased，the temperature for heating warps is increased，the anti—impact good The material can be used for a reciprocating compressor with 1a曙e scale，hi曲temperature and hjgh pressure，and has a great印plication value fof increasing the work time of piston ring ofreciprocating compressor in petro-chemicallndustry Key Words： PolynuortetraethyIene； Nylon 1010； Macromolecular composites ； TriboIogical BehaViors ll 兰州理工大学 兰州理工大学 学位论文原创性声明 本人郑重声明：所呈交的论文是本人在导师的指导下独立进行研究所取得的 研究成果。除了文中特别加以标注引用的内容外，本论文不包含任何其他个人或 集体已经发表或撰写的成果作品。对本文的研究做出重要贡献的个人和集体，均 已在文中以明确方式标明。本人完全意识到本声明的法律后果由本人承担。 作者签名：吾f桷处 吼州年7刖日