deltaigma数模转换器的理论与设计.docxVIP

优秀毕业论文 精品参考文献资料 Abstract The two cA)re technologies of the a-E DAC are ovcrsampling and noise shaping technology．Compared with other conventional DAC，the major advantages of A一∑ DAC are showed as following．The first,A一∑DAC can be integrated onto other di百hal devices due to its di百tal nature．The second，the cost of implementation is low because of simple technology．The last,A——E DAC is inherently linear and does not suffer from appreciable differential non—linearity and the background noise level which sets the system SNR independent of the input signal level．Besides of these，the most important advantage is that the A-E DAC is able to achieve high-performance and 11igh—precision which the conventional is not able to do． The a-E DAC consists of an upsampling module，a A—E modulator and a digital to analog converter．Because the design is implemented on FPGA，major researches in this paper focus on upsampling module and SDM． In this paper,we cascaded 3 halfband filters and a CIC filter to realize the upsampling module．The whole interpolation filter system has perfezt pass—band and stop-band performance and achieves a 64X oversmpling rate．We simplified the structure and save the logic dements by using multi—phase structure and CSD code in designing half band filters． After learning experiences and methods from other papers，we showed the design flow of the stable high—order A-Z modulator and designed a 5th·order 64一times one with CIFB structure based on the flow．We improved SNR about 1 7 dB through optimizing the NTF ZerOS and poles．In the design of circuit，we decreased amount of 109ic element through reusing adder and multiplier．The simulation result showed that the SNR ofthe modulator is above 120 dB． So far,this A-E DAC is implemented and verified by Altera Cyclone II EP2C35 FPGA． Keywords：DAC oversampling A-E modulation  西安电子科技大学 学位论文独创性(或创新性)声明 秉承学校严谨的学分和优良的科学道德，本人声明所呈交的论文是我个人在 导师指导下进行的研究工作及取得的研究成果。尽我所知，除了文中特别宓蟊以标 注和致谢中所罗列的肉容以外，论文中不包含其他入已经发表或撰写过的磷究成 果；也不包含为获得谣安电子科技大