基于can总线的汽车电子通信网络监控系统的设计与实现电子与通信工程专业论文.docxVIP

Design and Implementation of a Vehicle Electronic Communication Network Monitoring System Based on CAN-bus ABSTRACT In the 1980s, in order to solve information transmission problems between the interior testing parts and perform component in the automotive electronic system, CAN, Controller Area Network, as a serial bus communication protocol had been developed. CAN-bus can effectively support distributed control and real-time control of the area communication network.The short data frame structure, the undestructive arbitration bus mechanism and the high-speed data transmission ways of the CAN-bus meet the real time and reliability of the modern automotive electronic control system requirements. ISO, international standard organization, had developed CAN-bus protocol as an international standard in 1993. Because CAN-bus network has the abilities of communication at a high rate, low cost and good real-time performances and reliable ability to work in high noise environment, CAN almost turns into a must-used design technology in the automotive electronic control field at present. In this background, this paper puts forward a design scheme and Implementation of a vehicle electronic communication network monitoring system based on CAN-bus. System construct network nodes applied micro-controller and the special chips of CAN- bus, and design a special monitoring node in the network, for real-time monitoring the communication and information to the other nodes on the CAN-bus. This paper introduces the system hardware and software design method, focuses on the design method in the user CAN node application layer protocol of the monitor and control system, and completed the prototype production of the system. The experimental results show that the design CAN network monitor system communication operation is stable and reliable, and data nodes CAN realize more of the way for more communication, monitoring nodes CAN real-time monitoring network node of the condition of the ot