一级公路施工图设计大学毕业设计等(论文)土木工程道路勘测.docVIP

本科毕业设计(论文) 题目：河南汝阳至洛阳一级公路第六标段施工图设计 院 （系）： 建筑工程系 专 业： 土木工程专业交通土建方向 班 级： 姓 名： 学 号： 导 师： 年 月 河南汝阳至洛阳一级公路第六标段施工图设计 摘要 河南汝阳至洛阳一级公路是太澳、上（海）洛（阳）两条国家重点公路的重要组成部分，从洛阳市区开始，途经伊川县，从汝阳进入平顶山，是我国中东部的交通要道。它的建成对全国公路网络结构的完善，加快中西部经济社会发展具有极其重要的意义。拟建汝阳至洛阳一级公路第六标段，地处河南西部的山岭重丘地带，沟谷狭长，相互交错，转弯处多且急，地质构造复杂，全长3公里。 根据规范要求，结合当地实际情况，全线采用双向四车道一级公路标准，SMA路面，设计速度80km/h，路基宽度24.5m。本设计研究的内容包括：首先，根据交通量确定车道数，并在地形图上选线、定线，然后进行道路平面设计，纵断面设计，横断面设计，桥涵设置等。此外还对该路段的路基、路面、排水、边坡防护、涵洞及挡土墙进行了设计。 关键字：一级公路；选线；路基；SMA路面；涵洞 Construction Drawing Design of the 6th Contract Section of Ruyang-Luoyang Abstract The first class highway is the two national key highways’ important component, which starts from the Luoyang urban district, ways Yichuan County, enters Pingdingshan from Ruyang, is the key communication line of the mid- east. Its completion has extremely vital significance to consummate the national highway network architecture, speed up the mid-west economic and society development. Plans to construct Ruyang to the Luoyang first class highway section VI，is situated at the Henan western zone of the mountain re-Hill, long and narrow valley, cross-cutting, and more radical turn, the geological structure is complicated. It flows 3 kilometers. According to the code requirements and the local actual situation, uses the bidirectional four-lane first class highway standard on all fronts, the SMA Pavement, design speed of 80km/h, subgrade width of 24.5m.The contents of this design includes: first, according to the volume of traffic definites traffic lane number and elections on the topographic maps , sets route , and then proces to route graphic design, longitudinal design, cross-sectional design, such as cridges and culverts courses. In addition, the section of the subgrade, pavement , draining water, the side slope protection, the c