钻井工程英文课件1.12 Wellbore Stability.pptVIP

* Wellbore Stability 1.12-1 1.12-* Failure Modes Tensile Failure Shear Failure Matrix/Pore Collapse 1.12-* Symptoms The wellbore may slough because Initiation and/or extension of hydraulic fractures Local mobilization of pre-existing faults. Sudden spalling may occur during swabbing or tripping. Drag forces may cause rapid sand production. Ductile formations such as salt, other evaporites and soft shales can squeeze and restrict the hole. Certain shales can swell. 1.12-* Shale Stability Can be effected by: Exposure time Filtrate chemistry Ionic transport Dehydration (during UBD) 1.12-* Shale Stability The two most relevant mechanisms are: the hydraulic pressure difference between the wellbore pressure and the shale pore fluid pressure Chemical potential differences between the drilling and shale pore fluids. 1.12-* Smectitic Shales Ductile and creep Reduced wellbore pressure accelerates creep Chemically sensitive to mud filtrate’s ionic strength Imbibition can occur with subsequent swelling, and shoughing 1.12-* Smectitic Shales Salt, gilsonite or polymers can be added to the mud to stabilize these types of shales. 1.12-* Illitic Shales Higher quartz content and usually more stable that Smectitic shales Frequently more brittle and inert. However, massive failure can occur during high pressure drawdown due to the brittleness and stored energy within the pore fluids. 1.12-* Failure Criteria Von Mises Tresca Mohr-Coulomb Druker-Prager Hoek and Brown 1.12-* Mohr-Coulomb t = co + sn￠ tan f t shear stress (one-half of the difference between the maximum, and minimum principal stresses) sn￠ effective normal stress (average of the maximum and minimum effective principal stresses) co cohesion (intercept on a t - sn￠ plot), and, f angle of internal friction (angle of Mohr-Coulomb locus from the sn￠ axis on a t - sn￠ plot). 1.12-* Minimum Tolerable Pressures * This is an introduction to wellbore stability. * Tensile failure: This occurs if the maximum tensile