基于AVP技术的电压调节模块动态特性的研究-电力电子与电力传动专业论文.docxVIP

西南旋通大学硕士研究生学位论文 西南旋通大学硕士研究生学位论文 I 摘要 集或遵潞技术豹发袋瓣为其供电麓龟压调节模块的设诗提蹬了新魏挑竣， 为满足快速的负载变化，必须提高电雎调节模块的动态响应速度。 本文首先分析了电压调节模块的动态负载变化特点，描述了电压调节模块 的特殊要求，鳎弱提高电隧谖节模块动惫噙应速度静必要蛙及难点。 本文麓簧介绍了嚣裁备种疆离电送调节模块动悫响应速度的方法，在分橱 它们各自特点的基础上对其进行比较，阐述了采用AVP(Adaptive voltage position)设!)t改善电压调节模块动态特性的优越性。 本文第三囊建立了电聪调节模块不弱控制方法鲍小信号模型，霹j露小信号 模鍪，详缨分辑了毫压调节模块动态赞健与电路参数、控涮环路鹩关系，阐述 了临界电感与临界带宽的概念，得出了临界电感与临界带宽是电腿调节模块动 恣性能与效率之间很好的折衷。 最后，本文详细地讨论了AVP设计豹基本概念，指出利用AVP设计可以 密效建握毫VRM动态将饿，并在分餐豹萋磴主采蠲攥输受阻挠鹣设计方法， 宪成了电流型和V2型控制方法下的AVP设计，仿真结果验证了设计的正确性。 荚键词： 电愿调节模块 AVP设计 开关变换嚣 西南交通大学硕士研究生学位论文 西南交通大学硕士研究生学位论文 lI Abs仃act An evolution in integrated circuits poses new challenges for its power supply called voRage regulator modules(VRMs)．To meet the requirements of fast load transient response，VR_qVIS must improve its dynamic response． Transient characteristic dynamic 10ad of VRMS iS analyzed and specific requirements of VRlⅥs described in this thesis，The view is shown that it is di衢cuRy and essential improve dynamic response of、像Ms． Several different control methods described in brie￡which foCUS optimizing dynamic response of VRMs．The results obtained by investigating the features ofthese control methods show that adaptive vokage position(AVP)design gives an effective elevation feeding transient requirements ofVRMS． The small signal models for VRMs using various condol methods are derived． which are employed to explore the relationship between dynamic characteristic of VImS and circuit parameters．This thesis introduces the concept of critical bandwidth and critical inductance．Which good design仃adeOff between the e伍cieney and transient response for删S． Adaptive vokage position design is discussed particularly which Can enhance dynamic characteristic of VRMs．Both the current—mode and V‘control technique are analyzed in detail，Which are utilized achieve constant OUtpUt impedance，to approach perfect AVP for the VRMs transient response．Simulation results prove the theoretical analysis． Keyword：Vokage regulator modules Adaptive voRage