毕业设计（论文）-基于PROE的钻床夹具结构设计及运动仿真.docVIP

基于PRO/E的钻床夹具结构设计及运动仿真 摘 要：本文编制了拨叉、杠杆臂、轴环三个零件的机械加工工艺规程，并设计了加工拨叉锁销孔，杠杆臂10mm、 13mm两个相互垂直孔，轴环安装孔所用的钻床夹具。在夹具设计过程中主要是借助PRO/E软件的参数化造型模块完成了夹具各个零件的三维造型，又运用其装配管理功能把各个零件组装起来，最后完成夹具整体装配过程的动画仿真制作。三维造型的设计方法相对于传统的二维制图设计更清晰明了，在模拟装配仿真过程中可以及时发现问题，更有利于夹具结构的改进。 关键词：机械工艺规程，夹具，装配，仿真 Based on Pro/E of drilling fixture design and simulation Abstract：This article produced the machining process planning including three componentsthe——the fork, the lever arm and the axle collar , and designed the processing to dial the fork to lock the cotter 8mm hole, lever arm 10mm, the 13mm two mutually perpendicular holes, the drill fixture which the axle collar installment 10mm hole used. In the process of fixture design, PRO / E software for parametric modeling module is mainly used to complete the fixture in various parts of the three-dimensional modeling, and then its management capabilities are used to assemble various parts. Finally, the overall assembly process simulation animation production of fixture is completed. Three-dimensional modeling of the design compared to conventional two-dimensional graphic design is more clarity. We can find problems in the simulation assembly simulation process, so that making it more conducive to the improvement of the fixture structure. Key Words:machining process planning,fixture,assemble, simulation PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT I 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc263603237 前 言 PAGEREF _Toc263603237 \h 1 HYPERLINK \l _Toc263603238 1． 拨叉零件 PAGEREF _Toc263603238 \h 3 HYPERLINK \l _Toc263603239 1．1 拨叉的工艺分析 PAGEREF _Toc263603239 \h 3 HYPERLINK \l _Toc263603240 1．1．1 拨叉用途 PAGEREF _Toc263603240 \h 4 HYPERLINK \l _Toc263603241 1．1．2 拨叉的技术要求 PAGEREF _Toc263603241 \h 4 HYPERLINK \l _Toc263603242 1．1．3 审查拨叉的工艺性 PAGEREF _Toc263603242 \h 5 HYPERLINK \l _Toc263603243 1．1．4 零件毛坯的确定 PAGEREF _Toc263603243 \h 5 HYPERLINK \l _Toc263603244 1．2 拟定拨叉工艺路线 PAGEREF _Toc263603244 \h 5 HYPERLINK \l _Toc263603245 1．2．1 定位基准的选择 PAGEREF _Toc