端盖冲压模具设计说明书.doc

摘要 word文档整理分享 PAGE IV 参考资料 端盖冲压模具设计 摘 要 该工件采用倒装式落料拉深冲孔复合模。冲压工艺的选择是经查阅相关资料和对产品形状仔细分析的基础上确定的。在整个模具的设计中，首先对工件进行工艺分析，完成后开始确定工艺方案，基本的工序性质，对拉深次数进行确定，并确定工序的组合。模具设计中最重要的是模具结构的设计，在模具结构的设计过程中，确定模具的形式，要进行工艺的计算和校核，考需各个工序，对压力机进行初选。并在指导老师提供模具设计有关资料和同学帮助的情况下，完成了模具总装配图和所有零件图的绘制。在设计期间查阅了多种工具书和参阅模具结构图，对模具设计有了基础的认识。 关键词：端盖，落料，拉深，冲孔，复合模 Cover stamping mould design Pick to The workpiece using inversion type blanking deep drawing punching composite modulus. The choice is stamping process by access relevant information and product shape are determined on the basis of careful analysis. In the design of the mould, first of workpiece began after process analysis and complete process scheme, basic determined nature, deep drawing process to determine the number of times, and make sure the combination of processes. Mold design is the most important in the design of the mould structure, in the mold structure design process, determine the form of mould, want to undertake process, take an examination of to calculate and check for each working procedure, have been primaries. And in guiding the teacher provide mold design relevant data and classmates help, completed the mold assembly and all total component drawing. During the design a variety of dictionaries and refer to consult for mould design, mould structure, a basic understanding. Key wordS：Cover, blanking, deep drawing, punching, composite modulus 前言 目 录 前 言………………………………………………………………...1 第1章 冲件的工艺分析……………………………………………2 1.1 冲压件的结构形状分析…………………………………2 1.2 冲压件尺寸精度和表面质量的分析……………………...2 1.2.1 尺寸精度……………………………………… 2 1.2.2 冲压件断面质量分析…………………………….. 2 1.2.3 冲压件材料的分析……………………………….. 3 第2章 确定工艺方案………………………………………………4 2.1 确定基本的工序性质……………………………………4 2.2 确定拉深次数………………………………………. …4 2.2.1 计算毛坯直径D…………………………………4 2.2.2 判断拉深次数……………………………………4 2.3 确定工序组合………………………………………5 第3章 确定模具总体结构…………………………………………7 3.1 模具的形式……………………………………….……7 3.2 定位装置………………………………………….….…7 3.3 卸料装置………………………………………………7 3.4 导向零件………………………………………………7 3.5 模架………………………………………………………8 第4章 工艺