固体材料界面电阻实验研究-检测技术与自动化装置专业论文.docxVIP

ABSTRACTWith ABSTRACT With the rapid development of the wiring industries，the quality of the capability during也e interface of two contact conductor will affect the credibility of this wiring directly．Contact resistance of the interface iS a mostly parameter of assessing the capability of contact point．Good contact capability means that COntact resistance is little and steadv．Electrical phenomenon which that is contact resistante is an important index during the interface．It iS important ofresearching COntact resistance． hl tllis paper,we chose the interface between COPPer and aluminum testing pieces as the object to experiment and research．Research is based of experimentation and measuring parameters iS the basic problem which has to been settled during experimentation of interface resistance．Contact resistance iS small milliohm resistance．There is much factor which affects this contact resistance．And this factors which interact on each other make the research on contact resistance complex．So the means which measures contact resistance is very complex relatively．This PaDer has analyzed means which measures contact resistance from nation and overseas countries and provided measnre means which two rank surging circuit creates impulse current．And designed measure system by ourselves The measure system mainly is made of 24 bit data collection MCU ADUC845． And the measure system collects electric current and pressure in the measure loop． We expatiated and analyzed this measure system particularly from hardware and software and data collection software design based of ViSUal Basic．Because of weak electric current and pressure，sigrlaI managing part is adopted AD623 and OP 07 and low-pass．Tllis enhances collecting signal accuragy． Wb found the factors which affect the contact resistance between copper and aluminum testing pieces bv changing the experimental condition and the kinds of loads．Later we did qualitative analysis on the factors and analyzed how factors affect whe