08-Control of Power Features英文文献资料.pdfVIP

PS Moldmaker 7.0 8. Control Power Features 8. Control of Power Features The components that are created using wizards have common default setting for their use with power features. However there are situations that the defaults will not give the correct result. This chapter covers the methods and settings that can be used to control the application of power features to other components. Open the model – Control Power Features.psmodel and start assembly mode. The model contains a mixture of plates / components and inserts. The purpose of this model is purely to explain the control methods that can be used with power features  Generate Power Features from the Assembly tree for all of the components Issue PS Moldmaker 7.0 79 8. Control Power Features PS Moldmaker 7.0 On examination, the assembly tree reveals that the Extra Plate does not contain any holes for the Guide Bushes. As the Bushes are located in this plate then you would expect to see the fit holes. 80 Issue PS Moldmaker 7.0 PS Moldmaker 7.0 8. Control Power Features If you view the power features that have been applied to the Guide Pillar it can be seen that a hole from the Guide Bush has been copied incorrectly to the Pillar.  Select a Guide Pillar and blank except to see the hole from the Bush has “cut the Pillar in Half”  In the Assembly tree select a Pillar and using RMB view the Attributes, In this case the Power Feature Target attribute is turned ON This Attribute means that when Power Feature intersections are calculated the component will be considered as a target. Issue PS Moldmaker 7.0 81 8. Control Power F