关于OSPFRIP单臂路由配置.docxVIP

E 0/1 路由器 31 1; 0/0 192.168.2.1/24 启动动态路由I?办议RIP-2 2层DCS?A E 0/0/24 Trunk 划分Vian Vian 10 (1-8) Vlan20 (9-16) 分别在F0/1的了接口 添加地址 192.168.10.1/24 192.168.20.1/24 并进行封装 分别在F0/1的子接口 添加地址 192.168.100.1/24 192.168.200.1/24 并进行封装 2 B- F 0/1 F 0/0 192.168.2.2/24 划分Vian Vian 100 (1-8) Vlan20() (9-16) 2 层 DCS-B E 0/0/24 Trunk PCI Vian 10 192.168.10.10 255.255.255.0 192.168.10.1 PC2 Vlan200 192.168.200.20 255.255.255.0 192.168.200.1 如图所示：交换机AB划分対hWlain在路山器AB上作相应配置, K,使PCI-—ping—PC2相通，并写出详细配豐。 并使用动态路山RIP-2,经过配 a0/0 u PC-PTPCO 交换机SA FaO/24 FaO/lftiXM RB FaO/24 aO/9 SB PC-PT PC2 PC-PT PCI _「厂FaO/9 FaO/1^0-24 /SA PC-PT PC3 SWA#show vlan brief activeactiveactive active active active active active active active FaO/17, FaO/18, FaO/19, Fa0/20 FaO/21,FaO/22, FaO/23 FaO/1, FaO/2, Fa0/3, FaO/4 FaO/5, FaO/6, Fa0/7, FaO/8 FaO/9, Fa0/10, Fa0/ll, FaO/12 FaO/13, FaO/14, FaO/15, FaO/16 10 VLAN0010 20 VLAN0020 fddi-default token-ring-default fddinet-default trnet-default SWA# SWA#show interfaces trunk Port Mode Encapsulation Status Native vlan FaO/24 on 802」q trunking 1 Port FaO/24 Vlans allowed on trunk 1-1005 Port FaO/24 Vlans allowed and active in management domain 1,10,20 Port FaO/24 Vlans in spanning tree forwarding state and not pruned 1,10,20 SWA# 交换机SB SWB#show vlan brief 1 default active FaO/17, Fa0/18, FaO/19, Fa0/20 Fa0/21, FaO/22, Fa0/23 100 VLAN0100 active Fa0/l, FaO/2, Fa0/3, FaO/4 Fa0/5, FaO/6, Fa0/7, Fa0/8 200 VLAN0200 active FaO/9, Fa0/10, Fa0/ll, FaO/12 Fa0/l 3, FaO/14, Fa0/l 5, FaO/16 1002 fddi-default active 1003 token-ring-default active 1004 fddinet-default active 1005 trnet-default active SWB# SWB#show inter trunk Port Mode Encapsulation Status Native vlan FaO/24 on 802」q trunking 1 Port FaO/24 Vlans allowed on trunk 1-1005 Port FaO/24 Vlans allowed and active in management domain 1,100,200 Port FaO/24 Vlans in spanning tree forwarding state and not pruned 1,100,200 SWB# Rip 路由器RA： interface FastEthernetO/O ip address 192.162.1 255.255.255.0 duplex auto speed auto ! ■ i