机电专业英语教学课件作者凌淑莉7.pptVIP

Lesson 14 NC Part Programming 3) Mill the slot with a 0.75 in.four-flute flat,end mill made of carbide.From the Machine’s Ability Data Handbook,the recommended feed is 0.005in/tooth/rev and the recommended cutting speed is 620 fpm. 4) Drill two holes with a 0.75 in.diameter twist drill.Use 0.18 ipm feed and 100 fpm speed. (1) Solution To write a part program for the part，the cutting parameters need to be converted into rpm and ipm. 上一页 下一页 返回 Lesson 14 NC Part Programming (2) Milling N=12V/πD=12×620 fpm/π×0.75 in.=3,157 rpm Vf =fn N= 4 tpr×0.005 iprpt×3,157 rpm =63 ipm Where n=Number of te