热动力疏水阀工作原理.ppt

内容 蒸汽疏水阀的分类 热动力式 蒸汽疏水阀 热动力式蒸汽疏水阀 TLV专利的热动力式疏水阀 TLV热动力式疏水阀 构造 构造 构造 阀座构造 阀单元构造 阀单元构造 阀单元构造 阀单元构造 双金属片环 双金属片环 双金属片环 双金属片环 双金属片环 TLV的热动力式疏水阀 运行 空气排放 冷凝水的排放 冷凝水的排放 冷凝水的排放 冷凝水的排放 闪蒸汽 冷凝水的排放 速度和压力 速度及压力 速度和压力 冷凝水排放 冷凝水排放 冷凝水排放 各种力之间的关系 各种力之间的关系 各种力之间的关系 冷凝水排放 冷凝水排放 冷凝水排放 冷凝水排放 冷凝水排放 冷凝水排放 无负载状况 无负载状况 无负载状况 无负载状况 无负载状况 无负载状况 循环运行 TLV热动力式蒸汽疏水阀 特点及优点 快速空气排放 高精磨圆盘 空气夹套 空气夹套 空气夹套 空气夹套 空气夹套对蒸汽的节约 空气夹套对蒸汽的节约 TLV产品的特点及小结  无“气阻”现象 高精磨圆盘 坚硬的材质 空气夹套 长寿命 易维修保养 小结 疑问? 索引 This allows condensate to flow freely once again. Now again, condensate flashes into steam due to the pressure difference between inlet and outlet of the trap. The flash steam flows with a fast velocity under the disc, so creating an area of localized low pressure. The difference in pressures on both sides of the disc results in a difference in forces which causes the disc to move towards the seat. At the same time as the disc moves towards the seat, the pressure in the control chamber rises. This increases the pressure on the top side of the disc. The difference in pressures then results in a difference in forces which causes the disc to close onto the seat. The open and close cycle then continues to repeat. If there is superheated steam or virtually no condensate present then steam may enter the trap. Steam from the inlet of the trap flows to the outlet due to the difference in pressure. The steam flows extremely quickly under the disc. Consequently, the valve closes. However, in this case, sine there is no condensate there is no flash steam. The disc closes under the influence of live steam. Steam inside control chamber starts to condensate. Fpress becomes less than Finlet plust Foutlet. Finlet and Foutlet then push the disc upwards to open the valve. Live steam leaks again!!! It is now obvious that the operation pattern of thermodynamics trap is intermittent and a repeatable, open/close. When there is no condensate (such as with superheated steam conditions) live steam will leak. The ra