AWWA C222-2018 钢制水管及配件的聚氨酯涂料和衬里.pdf

ANSI/AWWA C222-18 (Revision of ANSI/AWWA C222-08) ® AWWA Standard Polyurethane Coatings and Linings for Steel Water Pipe and Fittings Effective date: May 1, 2018. First edition approved by AWWA Board of Directors June 20, 1999. This edition approved Jan. 20, 2018. Approved by American National Standards Institute Jan. 24, 2018. SM Copyright © 2018 American Water Works Association. All Rights Reserved. AWWA Standard This document is an American Water Works Association (AWWA) standard. It is not a specification. AWWA standards describe minimum requirements and do not contain all of the engineering and administrative information normally contained in specifications. The AWWA standards usually contain options that must be evaluated by the user of the standard. Until each optional feature is specified by the user, the product or service is not fully defined. AWWA publication of a standard does not constitute endorsement of any product or product type, nor does AWWA test, certify, or approve any product. The use of AWWA standards is entirely voluntary. This standard does not supersede or take precedence over or displace any applicable law, regulation, or code of any governmental authority. AWWA standards are intended to represent a consensus of the water industry that the product described will provide satisfactory service. When AWWA revises or withdraws this standard, an official notice of action will be placed in the Official Notice section ofJournal - American Water Works Association . The action becomes effective on the first day of the month following the month of Journal AWWA publication of the official notice. American National Standard An American National Standard implies a consensus of those substantially concerned with its s