c476-98中文版-砖石建筑用薄浆的标准规范.docVIP

C 476 PAGE 283 Designation: C 476 – 98编号：C 476 – 98 PAGE 282 Standard Specification for Grout for Masonry This specification is under the jurisdiction of ASTM Committee C-12 on Mortars for Unit Masonry and is the direct responsibility of Subcommittee C12.05 on Grout and Grout Admixtures for Masonary.本规范由ASTM This specification is under the jurisdiction of ASTM Committee C-12 on Mortars for Unit Masonry and is the direct responsibility of Subcommittee C12.05 on Grout and Grout Admixtures for Masonary.本规范由ASTM委员会C-12砌块灰浆委员会管辖，并由C12.05砖石建筑用薄浆和薄浆外加剂分委会直接负责。Current edition approved Jan. 10, 1998. Published November 1998. Originally published as C 476 - 61 T. Last previous edition C 476 - 95.现行版本于1998年1月10日批准，并于1998年11月出版。最初版本编号为C476-61T，上一版本编号为C476-95。 This standard is issued under the fixed designation C 476; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 476刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 1. Scope适用范围 This specification covers two types of grout, fine and coarse grout, for use in the construction of masonry structures. Grout is specified by: (1) proportions or (2) strength requirements.本规范包含砖石结构建筑用的两类薄浆——细薄浆和粗薄浆。薄浆由（1）比例或（2）强度要求规定。 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification.本标准的引用附注和脚注文本可提供说明材料。上述附注和脚注（不包括表格和图画里的附注、脚注）不应视为本标准的要求。 2. Referenced Documents参考文件 2.1 ASTM Standards: ASTM标准： C 5 Specification for Quicklime for Structural Purposes Annual Book of ASTM Stand