c700-98中文版-超强度及标准强度的多孔釉面陶土管标准规范.docVIP

C4 PAGE 2 Designation: C 700 – 98编号：C700-98 PAGE 1 Standard Specification forVitrified Clay Pipe, Extra Strength, Standard Strength, andPerforated This specification is under the jurisdiction of ASTM Committee C-4 on Vitrified Clay Pipe and is the direct responsibility of Subcommittee C04-20 on Methods of Test and Specifications该标准归ASTM委员会C-4釉面陶土管委员会管辖，并由负责标准试验方法和规范的C04.20小组委员会直接负责。Current edition approved March 10, 1998. Published March 1999. Originally published as C 700 - 71 T. Last previous edition C 700 - 97.现行版本于1998年3月10日批准，并于1999年3月出版。最初版本编号为C700-71T，上一版本编号为C 700-9 超强度及标准强度的多孔釉面陶土管标准规范1 This standard is issued under the fixed designation C 700; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C700刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.该标准已经批准被美国国防部机构使用。 1. Scope 适用范围 This specification establishes the criteria for acceptance, prior to installation, of extra strength and standard strength vitrified clay pipe and fittings to be used for the conveyance of sewage, industrial wastes, and storm water; and extra strength perforated and standard strength perforated vitrified clay pipe to be used for underdrainage, filter fields, leaching fields, and similar subdrainage installations.本规范确立了安装前的验收标准，验收对象包括用于运输污水、工业废料和雨水的超强度和标准强度釉面陶土管及其接头和用于地下排水系统、过滤器领域、沥滤领域以及相似的地下排水系统装置的超强度和标准强度多孔釉面陶土管。 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.以英制单位表示的数值为标准值，括号中给出的值仅供参考。 Note 1—Attention is called to Specification C 425, Test Method C 828, Test Method C 1091, Test Methods C 301, and Terminology C 896.注